Front USB module
CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before beginning any installation, removal, or replacement procedure. Improper grounding can cause electrostatic discharge.
- Power down the server.
- Remove all power:
- Disconnect each power cord from the power source.
- Disconnect each power cord from the server.
- Remove the access panel.
- Remove all USB devices from the front panel.
- Remove the tower bezel.
- Place the server on its side.
- If drives are installed in the drive cage, remove the drive cage.
- Disconnect the front USB module cable from the system board.
- Remove the front USB module:
- Remove one screw on the module from the front panel.
- Move the module down and pull the cable out from the chassis.
To replace the components, reverse the removal procedure.