ERPS tasks at a glance
To configure ERPS, perform the following tasks:
Perform this task on devices you want to configure as ERPS nodes.
Perform this task on all nodes on an ERPS ring.
Perform this task on all nodes on an ERPS ring.
(Optional.) Enabling R-APS packets to carry the ring ID in the destination MAC address
Perform this task on all nodes on an ERPS ring.
(Optional.) Configuring R-APS packet levels
(Optional.) Setting ERPS timers
Perform this task on the owner node on an ERPS ring.
(Optional.) Setting the non-revertive mode
Perform this task on the owner node on an ERPS ring.
(Optional.) Setting a switchover mode
Perform this task on the nodes that you want to block their ports.
(Optional.) Associating a ring with a subring
Perform this task on the interconnection node on an ERPS ring.
(Optional.) Enabling flush packet transparent transmission
Perform this task on the interconnection node on an ERPS ring.
(Optional.) Associating an ERPS ring member port with a track entry
(Optional.) Removing the MS mode and FS mode settings for an ERPS ring