Configuring a static member port

About static member ports

You can configure a port as a static member port for an IPv6 multicast group so that all hosts attached to the port can always receive IPv6 multicast data for the group. The static member port does not respond to MLD queries. When you complete or cancel this configuration, the port does not send an unsolicited report or done message.

Procedure

  1. Enter system view.

    system-view

  2. Enter Layer 2 interface view.

    • Enter Layer 2 Ethernet interface view.

      interface interface-type interface-number

    • Enter Layer 2 aggregate interface view.

      interface bridge-aggregation interface-number

  3. Configure the port as a static member port.

    mld-snooping static-group ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id

    By default, a port is not a static member port.