Installing and removing a power supply (HPE 5130 24G SFP 4SFP+ EI switch)

	CAUTION: Provide a circuit breaker for each power supply and make sure the circuit breaker is off before installation.

The HPE 5130 24G SFP 4SFP+ EI switch provides two power supply slots and comes with power supply slot 1 empty and a filler panel in power supply slot 2. You can install one power supply, or two power supplies for redundancy. For information about power supplies available for the HPE 5130 24G SFP 4SFP+ EI switch, see "Appendix B FRUs."

When two power supplies are installed, you can hot-swap a power supply. To avoid device damage and bodily injury, follow the procedures in Figure 16 and Figure 17 to install and replace a power supply.

The installation and removal procedures are the same for the PSR150-A/PSR150-A1(JD362A/JD362B) and PSR150-D/PSR150-D1(JD366A/JD366B) power supplies. This guide uses the PSR150-A1 (JD362B) power supply as an example.