Configuring DLSw in an Ethernet environment
Step | Command | Remarks |
|---|---|---|
1. Enter system view. | system-view | N/A |
2. Enable bridging. | bridge enable | N/A |
3. Enable a bridge set. | bridge bridge-set enable | N/A |
4. Enable DLSw. | dlsw enable | Optional. Enabled by default. |
5. Create a local DLSw peer. | See "Creating DLSw peers." | N/A |
6. Map a bridge set to DLSw. | See "Mapping a bridge set to DLSw." | N/A |
7. Add an Ethernet interface to the bridge set. | N/A | |
8. Set DLSw timers. | See "Setting DLSw timers." | Optional. |
9. Configure LLC2 parameters. | See "Configuring LLC2 parameters." | Optional. |
10. Configure the multicast function of DLSw v2.0. | Optional. | |
11. Configure the maximal attempts of sending an explorer frame in DLSw v2.0. | See "Configuring the maximum number of DLSw v2.0 explorer retries." | Optional. |
12. Apply an ACL in DLSw so DLSw handles only Ethernet frames that match the ACL. | See "Applying an ACL in DLSw." | Optional. |
13. Configure DLSw Ethernet redundancy. | Optional. | |
14. Configure local reachable MAC or SAP addresses. | Optional. | |
15. Configure the remote reachability information for the router. | Optional. | |
16. Configure DLSw load balancing. | Optional. |
For more information on bridging and bridge set configuration, see "Configuring bridging."