Mapping a bridge set to DLSw

DLSw was developed based on the bridging technology. Bridging between different Ethernet interfaces is possible if these interfaces are configured in the same bridge set. To enable forwarding frames of a bridge set to a remote end system over a TCP connection, use the dlsw bridge-set command to map the bridge set to DLSw. You can map multiple bridge sets to DLSw.

To map a bridge set connected to DLSw:

Step	Command	Remarks
1. Enter system view.	system-view	N/A
2. Map a bridge set to DLSw.	dlsw bridge-set bridge-set	By default, no bridge set is mapped to DLSw. This command should be used in conjunction with the bridge bridge-set enable command, with the same bridge-set value in both commands.

Step

Command

Remarks

1. Enter system view.

system-view

N/A

2. Map a bridge set to DLSw.

dlsw bridge-set bridge-set

By default, no bridge set is mapped to DLSw.

This command should be used in conjunction with the bridge bridge-set enable command, with the same bridge-set value in both commands.

prev	up	next
Creating DLSw peers	home	Adding an Ethernet interface to a bridge set