|
Event |
Message |
|---|---|
|
RIPng has been configured on the device with the CLI command |
RIPng is enabled. |
|
RIPng has been un-configured on the device with the CLI command router ripng disable. |
RIPng is disabled. |
|
RIPng has been un-configured on the device with the CLI command |
RIPng is disabled. |
|
An incoming RIPng packet has been rejected because the source address is not IPv6. |
Bad packet – protocol is not IPv6. |
|
An incoming RIPng packet has been rejected because the source address is not link-local. |
Bad packet – source address must be link-local. |
|
An incoming RIPng packet has been rejected because the version number is invalid. |
Bad packet – version must be 1. |
|
An incoming RIPng packet has been rejected because the interface it was received on is marked to restrict RIPng updates. |
Bad packet – received packet dropped on an interface that is marked to restrict RIPng updates. |
|
An incoming RIPng packet has been rejected because it was sent by the switch itself. |
Bad packet – originator and receiver are the same. |
|
An incoming RIPng packet has been rejected because the reserved header field was not set to zero. |
Bad packet – reserved field must be zero. |
|
An incoming RIPng packet has been rejected because the hop limit is not 255. |
Bad packet – hop limit must be 255. |
|
An incoming RIPng packet has been rejected because the source port is not valid. |
Bad packet – source port must be 521. |