Syntax:
These three commands list the switch ports configured for meshing, along with the state of each mesh-configured connection, the hostname and MAC address of the switch on the opposite end of the link (Adjacent Switch), the MAC address of the port on the opposite end of the link (Peer Port), and whether or not any mesh warnings have been generated. Mesh warnings are written to the event log.
The switch presents show mesh output in the following format:
Adjacent Hosts Port State | Hostname Address Peer Port Mesh Warning ----- ----------- + -------- ----------- ----------- ------------ See the log file for details of warnings.
Viewing show mesh
output
North#: show mesh Adjacent Hosts Port State | Hostname Address Peer Port Mesh Warning ------ --------------- + -------- ------------- ------------- ------------ 13 Established | East 001560-f9e300 001560-f9f3f3 No 14 Established | South 001f28-244a00 001f28-245ac3 No 15 Established | West 001279-884300 001279-8853f3 No See the log file for details of warnings.
Syntax:
Lists information about devices connected to the switch mesh in the following format.
MAC Address VLAN Port Owner Switch Hostname ------------ ---- ---- ------ ------- ----------
|
|
NOTE: The information shown by the |
|
|
Viewing device information
For the mesh topology shown in A mesh topology, the show mesh mac-address
command issued from the North switch displays the following device information. This listing shows the MAC addresses of the clients connected to the South, East, and West switches.
North#: show mesh mac-address MAC Address VLAN Port Owner Switch Hostname ------------ ---- ---- ------------- ---------- 001517-0bdc0c 1 14 001f28-244a00 South 001517-0bdc8d 1 13 001560-f9e300 East 000e0c-33b2a8 1 15 001279-884300 West There are 3 addresses in the meshing address table
Syntax:
Traces the route from a source switch in a mesh to a device connected to the mesh.
The number of the port through which the trace enters the switch.
The number of the port through which the trace exits the switch.
The direction of the trace is from the originating switch to the target device.
Viewing traceroute information
For the example mesh topology shown in A mesh topology, the following switch mesh traceroute
command traces the route to the client attached to the South switch.
North#: show mesh traceroute mac-address 001517-0bdc0c vlan 1 Traceroute to MAC Address: 001517-0bdc0c VID: 1 Hop Address Hostname Inbound-Port Outbound-Port 0 0024a8-d60b80 North 13 1 001560-f9e300 East A13 A14 2 001f28-244a00 South C14 A1 Trace route is completed. Total hops to destination is 3
|
|
NOTE: In this case the trace traverses two links (North-to-East and East-to-South), rather than going directly from the North switch to the South switch. The mesh chooses the route based on traffic loads on the links and other factors. As a result, the mesh may choose different paths between any two points at different times. You may notice these differences when you trace routes through the mesh. |
|
|