Syntax:
Enables or disables meshing operation on the specified ports.
Specifies the mesh ID. It must be unique; if two switches in a mesh are assigned the same mesh ID, they auto-negotiate and generate unique IDs. Only configured mesh IDs can be changed by a user.
NOTE: When the mesh ID is configured, a reboot is required for this ID to take effect.
To view the mesh IDs, enter the
show mesh id
command.The
no mesh id
command resets the configured mesh ID to zero.
All meshed ports on a switch belong to the same mesh domain. To configure multiple meshed ports on a switch:
Configuring meshing
To configure meshing on ports A1-A4, B3, C1, and D1-D3:
HP Switch(config)#: mesh a1-a4, b3, c1, d1-d3
Command will take effect after saving configuration and reboot.
HP Switch(config)#: write memory
HP Switch(config)#: boot
Device will be rebooted, do you want to continue [y/n]?
Y
Removing a port from meshing
To remove a port from meshing, use the no version of mesh
, followed by write memory
and rebooting the switch. For example, to remove port C1 from the mesh:
HP Switch#: config HP Switch(config)#: no mesh c1 Command will take effect after saving configuration and reboot. HP Switch(config)#: write memory HP Switch(config)#: boot Device will be rebooted, do you want to continue [y/n]? y