port hybrid ip-subnet-vlan

Use port hybrid ip-subnet-vlan to associate a port with the specified IP subnet-based VLAN.

Use undo port hybrid ip-subnet-vlan to disassociate a port from the specified IP subnet-based VLAN.

Syntax

port hybrid ip-subnet-vlan vlan vlan-id

undo port hybrid ip-subnet-vlan { vlan vlan-id | all }

Default

A port is not associated with an IP subnet-based VLAN.

Views

Layer 2 Ethernet interface view

Layer 2 aggregate interface view

Predefined user roles

network-admin

mdc-admin

Parameters

vlan vlan-id: Specifies a VLAN by its ID in the range of 1 to 4094.

all: Specifies all VLANs.

Usage guidelines

For this command to take effect, perform the following tasks:

1. Create a VLAN and associate it with the specified IP subnet or IP address.

2. Set the port link type to hybrid.

3. Configure the port to allow the IP subnet-based VLAN to pass through.

Examples

# Associate Ten-GigabitEthernet 1/0/1 with IP subnet-based VLAN 3.

<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] ip-subnet-vlan ip 192.168.1.0 255.255.255.0
[Sysname-vlan3] quit
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port link-type hybrid
[Sysname-Ten-GigabitEthernet1/0/1] port hybrid vlan 3 untagged
[Sysname-Ten-GigabitEthernet1/0/1] port hybrid ip-subnet-vlan vlan 3

# Associate Layer 2 aggregate interface Bridge-Aggregation 1 with IP subnet-based VLAN 3.

<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] ip-subnet-vlan ip 192.168.1.0 255.255.255.0
[Sysname-vlan3] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 3 untagged
[Sysname-Bridge-Aggregation1] port hybrid ip-subnet-vlan vlan 3

Related commands

display ip-subnet-vlan interface

display ip-subnet-vlan vlan

ip-subnet-vlan