port-isolate enable

Use port-isolate enable to assign a port to an isolation group.

Use undo port-isolate enable to remove a port from an isolation group.

Syntax

port-isolate enable group group-id

undo port-isolate enable

Default

The port is not assigned to any isolation group.

Views

Layer 2 Ethernet interface view

Layer 2 aggregate interface view

Predefined user roles

network-admin

mdc-admin

Parameters

group group-id: Specifies an isolation group by its ID. The value range is 1 to 8.

Usage guidelines

The configuration in Layer 2 Ethernet interface view applies only to the interface.

The configuration in Layer 2 aggregate interface view applies to the Layer 2 aggregate interface and its aggregation member ports. If the device fails to apply the configuration to the aggregate interface, it does not assign any aggregation member port to the isolation group. If the failure occurs on an aggregation member port, the device skips the port and continues to assign other aggregation member ports to the isolation group.

You cannot assign the member ports of a service loopback group to an isolation group, and vice versa.

To assign ports to an isolation group, make sure the isolation group already exists.

One port can be assigned to only one isolation group.

Examples

# Assign Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2 to isolation group 1.

<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port-isolate enable group 1
[Sysname-Ten-GigabitEthernet1/0/1] quit
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] port-isolate enable group 1

Related commands

display port-isolate group