display port-isolate group
Use display port-isolate group to display port isolation group information.
Syntax
display port-isolate group [ group-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
group-id: Specifies an isolation group by its ID. The value range is 1 to 8.
Examples
# Display all isolation groups.
<Sysname> display port-isolate group
Port isolation group information:
Group ID: 1
Group members:
Ten-GigabitEthernet1/0/1
Group ID: 5
Group members:
Ten-GigabitEthernet1/0/2 Ten-GigabitEthernet1/0/4
Community VLAN ID: 3
# Display information about isolation group 1.
<Sysname> display port-isolate group 1
Port isolation group information:
Group ID: 1
Group members:
Ten-GigabitEthernet1/0/1
Community VLAN ID: 1(default), 2
Table 11: Command output
Field | Description |
|---|---|
Group ID | ID of the isolation group. |
Group members | Isolated ports in the isolation group. No ports indicates that the isolation group contains no isolated ports. |
Community VLAN ID | IDs of the community VLANs in the isolation group. None indicates that the isolation group contains no community VLANs. |
Related commands
port-isolate enable