control-vlan
Use control-vlan to configure the primary control VLAN for the RRPP domain.
Use undo control-vlan to remove the primary control VLAN from the RRPP domain.
Syntax
control-vlan vlan-id
undo control-vlan
Default
No control VLAN exists in the RRPP domain.
Views
RRPP domain view
Predefined user roles
network-admin
Parameters
vlan-id: Specifies the ID of the primary control VLAN, in the range of 2 to 4093. The VLAN must have not been created yet.
Usage guidelines
When you configure control VLANs for an RRPP domain, you only need to configure the primary control VLAN. The system automatically configures the secondary control VLAN. It uses the primary control VLAN ID plus 1 as the secondary control VLAN ID. For the control VLAN configuration to succeed, make sure the IDs of the two control VLANs are consecutive and have not been assigned yet.
To ensure correct forwarding of RRPPDUs, follow these guidelines:
Do not configure the default VLAN of a port accessing an RRPP ring as the control VLAN.
Do not enable QinQ or VLAN mapping on the control VLANs.
After you configure RRPP rings for an RRPP domain, you cannot delete or modify the primary control VLAN of the domain. To do so, use the undo control-vlan command.
Examples
# Configure VLAN 100 as the primary control VLAN of RRPP domain 1 (assume that VLAN 100 and VLAN 101 have not been created yet).
<Sysname> system-view [Sysname] rrpp domain 1 [Sysname-rrpp-domain1] control-vlan 100