QinQ configuration task list
When you configure QinQ, follow these guidelines:
QinQ requires configurations only on the service provider network.
QinQ configurations made in Ethernet interface view take effect on the current interface only. Those made in Layer 2 aggregate interface view take effect on the current aggregate interface and all the member ports in the aggregation group. Those made in port group view take effect on all member ports in the current port group.
Do not configure QinQ on a reflector port. For more information about reflector ports, see Network Management and Monitoring Configuration Guide.
On a port with basic QinQ enabled, you must configure the port to allow packets from its PVID to pass through. On a port with selective QinQ enabled, you must configure the port to allow packets from the outer VLANs of QinQ packets to pass through.
Complete the follows tasks to configure QinQ:
Task | Remarks | |
|---|---|---|
Required | ||
Optional | ||
Required Perform at least one of these tasks. | ||
Optional | ||