portal move-mode auto
Syntax
portal move-mode auto
undo portal move-mode
View
System view
Default level
2: System level
Parameters
None
Description
Use portal move-mode auto to enable support for portal user moving. Then, if an authenticated user moves from a port of the device to another port of the device without logging off, the user can continue to access the network (without re-authentication) if the following conditions are satisfied:
The new port is up.
The original port and the new port belong to the same VLAN.
The authorization information of the user, if any, is assigned to the new port successfully.
If any condition is not satisfied, the device re-authenticates the user on the new port.
Use undo portal move-mode to disable support for portal user moving.
By default, support for portal user moving is disabled, and if an authenticated user moves from a port of the device to another port of the device without logging off, the user cannot get online when the original port is still up, because the original port is still maintaining the authentication information of the user.
If the original port goes down after a user moves from the port to another port, the authentication information of the user is lost and the user has to be re-authenticated.
Support for portal user moving applies to scenarios where hubs, Layer 2 switches, or APs exist between users and the access devices.
Examples
# Enable support for portal user moving.
<Sysname> system-view [Sysname] portal move-mode auto