Packet type-based local PBR configuration example

As shown in Figure 72, configure PBR on Switch A to forward all TCP packets to the next hop 1.1.2.2. Switch A forwards other packets according to the routing table.

1. Configure Switch A:

   # Create VLAN 10 and VLAN 20.

   <SwitchA> system-view
   [SwitchA] vlan 10
   [SwitchA-vlan10] quit
   [SwitchA] vlan 20
   [SwitchA-vlan20] quit
   

   # Configure the IP addresses of VLAN-interface 10 and VLAN-interface 20.

   [SwitchA] interface vlan-interface 10
   [SwitchA-Vlan-interface10] ip address 1.1.2.1 24
   [SwitchA-Vlan-interface10] quit
   [SwitchA] interface vlan-interface 20
   [SwitchA-Vlan-interface20] ip address 1.1.3.1 24
   [SwitchA-Vlan-interface20] quit
   

   # Configure ACL 3101 to match TCP packets.

   [SwitchA] acl number 3101
   [SwitchA-acl-adv-3101] rule permit tcp
   [SwitchA-acl-adv-3101] quit
   

   # Configure Node 5 for policy aaa to forward TCP packets to next hop 1.1.2.2.

   [SwitchA] policy-based-route aaa permit node 5
   [SwitchA-pbr-aaa-5] if-match acl 3101
   [SwitchA-pbr-aaa-5] apply next-hop 1.1.2.2
   [SwitchA-pbr-aaa-5] quit
   

   # Configure local PBR by applying policy aaa to Switch A.

   [SwitchA] ip local policy-based-route aaa
   

2. Configure Switch B:

   # Create VLAN 10.

   <SwitchB> system-view
   [SwitchB] vlan 10
   [SwitchB-vlan10] quit
   

   # Configure the IP address of VLAN-interface 10.

   [SwitchB] interface vlan-interface 10
   [SwitchB-Vlan-interface10] ip address 1.1.2.2 24
   

3. Configure Switch C:

   # Create VLAN 20.

   <SwitchC> system-view
   [SwitchC] vlan 20
   [SwitchC-vlan20] quit
   

   # Configure the IP address of VLAN-interface 20.

   [SwitchC] interface vlan-interface 20
   [SwitchC-Vlan-interface20] ip address 1.1.3.2 24
   

# Telnet to Switch B on Switch A. The operation succeeds.

# Telnet to Switch C on Switch A. The operation fails.

# Ping Switch C from Switch A. The operation succeeds.

Telnet uses TCP and ping uses ICMP. The preceding results show that all TCP packets sent from Switch A are forwarded to the next hop 1.1.2.2, and other packets are forwarded through VLAN-interface 20. The local PBR configuration is effective.