Installation preparation
Before placing the switch on a workbench or on the floor, confirm the following preparations:
The workbench or floor is sturdy enough to support the weight of the chassis and its accessories.
The workbench or floor is correctly grounded.
Position the installation holes and drill holes.
Make sure each hole is exact in diameter and depth for the anchor.
Assemble each wall anchor by inserting the spade-shaped wedges on the plug into the grooves on the shank.
Put the assembled wall anchors into installation holes and hammer them into the ground.
The wall anchors are installed.
Figure 20: Installing the wall anchor
(1) Shank | (2) Groove |
(3) Plug | (4) Spade-shaped wedge |