Basic IPv6 static route configuration example

As shown in Figure 92, configure IPv6 static routes so that hosts can reach one another.

1. Configure the IPv6 addresses for all VLAN interfaces. (Details not shown.)

2. Configure IPv6 static routes:

   # Configure a default IPv6 static route on Switch A.

   <SwitchA> system-view
   [SwitchA] ipv6 route-static :: 0 4::2
   

   # Configure two IPv6 static routes on Switch B.

   <SwitchB> system-view
   [SwitchB] ipv6 route-static 1:: 64 4::1
   [SwitchB] ipv6 route-static 3:: 64 5::1
   

   # Configure a default IPv6 static route on Switch C.

   <SwitchC> system-view
   [SwitchC] ipv6 route-static :: 0 5::2
   

3. Configure the IPv6 addresses for all the hosts and configure the default gateway of Host A, Host B, and Host C as 1::1, 2::1, and 3::1.

# Display the IPv6 static route information on Switch A.

[SwitchA] display ipv6 routing-table protocol static

Summary Count : 1

Static Routing table Status : <Active>
Summary Count : 1

Destination: ::                                          Protocol  : Static
NextHop    : 4::2                                        Preference: 60
Interface  : Vlan-interface200                           Cost      : 0

Static Routing table Status : <Inactive>
Summary Count : 0

# Display the IPv6 static route information on Switch B.

[SwitchB] display ipv6 routing-table protocol static

Summary Count : 2

Static Routing table Status : <Active>
Summary Count : 2

Destination: 1::/64                                      Protocol  : Static
NextHop    : 4::1                                        Preference: 60
Interface  : Vlan-interface200                           Cost      : 0

Destination: 3::/64                                      Protocol  : Static
NextHop    : 5::1                                        Preference: 60
Interface  : Vlan-interface300                           Cost      : 0

Static Routing table Status : <Inactive>
Summary Count : 0

# Use the ping command to test the reachability.

[SwitchA] ping ipv6 3::1
Ping6(56 data bytes) 4::1 --> 3::1, press CTRL_C to break
56 bytes from 3::1, icmp_seq=0 hlim=62 time=0.700 ms
56 bytes from 3::1, icmp_seq=1 hlim=62 time=0.351 ms
56 bytes from 3::1, icmp_seq=2 hlim=62 time=0.338 ms
56 bytes from 3::1, icmp_seq=3 hlim=62 time=0.373 ms
56 bytes from 3::1, icmp_seq=4 hlim=62 time=0.316 ms

--- Ping6 statistics for 3::1 ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/std-dev = 0.316/0.416/0.700/0.143 ms