Setting modem negotiation parameters on an FCM interface
You can set the modem negotiation parameters on an FCM interface as needed.
To set the modem negotiation parameters on an FCM interface:
Step | Command | Remarks |
|---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter FCM interface view. | interface fcm interface-number | N/A |
3. Set the off-hook delay time after receiving ring tones. | negotiation hookoff value | Optional. |
4. Set the length of time for sending scramble binary 1. | negotiation scramble-binary1 value | Optional. |
5. Set the length of time for sending unscramble binary 1. | negotiation unscramble-binary1 value | Optional. |
6. Set the silence time. | negotiation silence value | Optional. |
7. Set the maximum wait time for a response to a sent U frame. | negotiation u-frame timeout value | Optional. |
8. Set the number of retries for sending a U frame. | negotiation u-frame retry value | Optional. |
9. Set the maximum wait time for a response to a sent S frame. | negotiation s-frame timeout value | Optional. |
10. Set the number of retries for sending an S frame. | negotiation s-frame retry value | Optional. |
11. Set the maximum wait time for the next character. | negotiation rx timeout value | Optional. |
12. Set the number of times for no carrier state detection. | negotiation no-carrier-detect retry value | Optional. |
13. Enable no carrier state detection. | negotiation no-carrier-detect software | Optional. |
14. Enable line quality detection. | negotiation line-quality-detect enable | Optional. |
15. Enable transmit power adaptation and set the incremental value. | negotiation txpower { handshake | always } value | Optional. |
16. Enable fast negotiation. | negotiation fast-mode | Optional. |
17. Enable V.22 BIS modem negotiation protocol. | negotiation V22bis | Optional. Only FIC-E1POS supports this command. |
18. Set the answer tone power gain. | threshold answer-tone value | Optional. |
19. Set the maximum strength value of incoming signals. | threshold risdon value | Optional. |
20. Set the minimum strength value of incoming signals. | threshold rlsdoff value | Optional. |
21. Set the transmit power gain. | threshold txpower value | Optional. |