Load balancing configuration example for LAN-to-LAN DLSw

As shown in Figure 85:

• DLSw operates in LAN-to-LAN mode.

• Configure DLSw on Router A, Router B, and Router C to connect the IBM host with the SNA host through the Internet.

• Configure DLSw load balancing on Router A.

1. Configure Router A:

   # Configure interfaces on Router A to make sure that the local DLSw peer 1.1.1.1 and remote peers 2.2.2.2 and 3.3.3.3 can reach each other. (Details not shown.)

   # Configure DLSw and enable DLSw load balancing on Router A.

   <RouterA> system-view
   [RouterA] bridge enable
   [RouterA] bridge 5 enable
   [RouterA] dlsw local 1.1.1.1
   [RouterA] dlsw remote 2.2.2.2 circuit-weight 20
   [RouterA] dlsw remote 3.3.3.3 circuit-weight 30
   [RouterA] dlsw load-balance
   [RouterA] dlsw bridge-set 5
   [RouterA] interface ethernet 1/0
   [RouterA-Ethernet1/0] bridge-set 5
   

2. Configure Router B:

   # Configure interfaces on Router B to make sure that the local DLSw peer 2.2.2.2 and remote peer 1.1.1.1 can reach each other. (Details not shown.)

   # Configure DLSw on Router B.

   <RouterB> system-view
   [RouterB] bridge enable
   [RouterB] bridge 5 enable
   [RouterB] dlsw local 2.2.2.2
   [RouterB] dlsw remote 1.1.1.1
   [RouterB] dlsw bridge-set 5
   [RouterB] interface ethernet 1/0
   [RouterB-Ethernet1/0] bridge-set 5
   

3. Configure Router C:

   # Configure interfaces on Router C to make sure that the local DLSw peer 3.3.3.3 and remote peer 1.1.1.1 can reach each other. (Details not shown.)

   # Configure DLSw on Router C.

   <RouterC> system-view
   [RouterC] bridge enable
   [RouterC] bridge 5 enable
   [RouterC] dlsw local 3.3.3.3
   [RouterC] dlsw remote 1.1.1.1
   [RouterC] dlsw bridge-set 5
   [RouterC] interface ethernet 1/0
   [RouterC-Ethernet1/0] bridge-set 5