Configuring DLSw
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Enable DLSw. | dlsw enable | Optional. Enabled by default. |
3. Create a local DLSw peer. | See "Creating DLSw peers." | N/A |
4. Configure an SDLC interface. | N/A | |
5. Enable DLSw forwarding on an SDLC interface. | N/A | |
6. Configure SDLC roles. | See "Configuring SDLC roles." | N/A |
7. Configure an SDLC address for a secondary station. | N/A | |
8. Configure an SDLC peer. | See "Configuring an SDLC peer." | N/A |
9. Configure the XID of SDLC. | See "Configuring an SDLC XID." | Optional (required for PU2.0 devices). |
10. Configure an SDLC virtual MAC address. | Optional. | |
11. Configure the properties of a synchronous serial interface. | See "Configuring the properties of a synchronous serial interface." | Optional. |
12. Configure optional SDLC parameters. | Optional. | |
13. Configure the multicast function of DLSw v2.0. | Optional. | |
14. Configure the maximal number of DLSw v2.0 explorer retries. | See "Configuring the maximum number of DLSw v2.0 explorer retries." | Optional. |
15. Configure local reachable MAC or SAP addresses. | Optional. | |
16. Configure the remote reachability information. | Optional. | |
17. Configure DLSw load balancing. | Optional. |