Configuring a PPPoE session
Step | Command | Remarks |
|---|---|---|
1. Enter system view. | system-view | N/A |
2. Create a VT interface and enter VT interface view. | interface virtual-template number | N/A |
3. Set PPP parameters. | See "Configuring PPP." | If authentication is needed, use the PPPoE server as the authenticator. |
4. Enable MRU verification. | ppp lcp echo mru verify [ minimum value ] | By default, MRU verification is disabled. |
5. Return to system view. | quit | N/A |
6. Enter Layer 3 Ethernet interface/subinterface, VLAN interface, Layer 3 aggregate interface/subinterface, or L3VE interface/subinterface view. | interface interface-type interface-number | N/A |
7. Enable the PPPoE server on the interface and bind this interface to the specified VT interface. | pppoe-server bind virtual-template number | By default, the PPPoE server is disabled on the interface. |
8. (Optional.) Configure an access concentrator (AC) name for the PPPoE server. | pppoe-server tag ac-name name | By default, the AC name for the PPPoE server is the device name. PPPoE clients can choose a PPPoE server according to the AC name. The device does not support this feature. |
9. (Optional.) Enable the PPPoE server to support the ppp-max-payload tag and specify a range for the PPP maximum payload. | pppoe-server tag ppp-max-payload [ minimum minvalue maximum maxvalue ] | By default, The PPPoE server does not support the ppp-max-payload tag. |
10. (Optional.) Set a service name for the PPPoE server | pppoe-server tag service-name name | By default, the PPPoE server does not have a service name. |
11. (Optional) Set the response delay time for user access. | pppoe-server access-delay delay-time | By default, no response delay time is set. |
12. Return to system view. | quit | N/A |
13. Configure the PPPoE server to perform authentication, authorization, and accounting for PPP users. | See Security Configuration Guide. | N/A |