Configuring the portal service
Configuring UAM as the portal server
Click the User tab.
From the navigation tree, select User Access Policy > Portal Service > Server.
The Server page opens.
On the Service Type List area, click Add, as shown in Figure 17.
The Add Service Type page opens.
Figure 17: Accessing the Server page
Configure the service type parameters, as shown in Figure 18:
Enter portal in the Service Type ID field.
Enter office in the Service Type field.
Figure 18: Adding a service type
Click OK.
The new service type named portal is added to the service type list, as shown in Figure 19.
Figure 19: Viewing the new service type
Use default values for other parameters.
Click OK.
Configuring an IP group
Click the User tab.
From the navigation tree, select User Access Policy > Portal Service > IP Group.
The IP Group page opens, as shown in Figure 20.
Figure 20: Accessing the IP Group page
On the IP group list, click Add.
The Add IP Group page opens.
Configure the IP group parameters, as shown in Figure 21:
Enter portal_test in the IP Group Name field.
Enter 192.168.75.1 in the Start IP field.
Enter 192.168.75.254 in the End IP field.
The IP address of the PC running the iNode client must be included in this IP segment.
Figure 21: Adding an IP group
Click OK.
The new IP group named portal_test is added to the IP group list, as shown in Figure 22.
Figure 22: Viewing the new IP group
Configuring the switch as a portal device
Click the User tab.
From the navigation tree, select User Access Policy > Portal Service > Device.
The Device page opens, as shown in Figure 23.
Figure 23: Accessing the Device page
On the device list, click Add.
The Add Device page opens.
Configure the portal device parameters, as shown in Figure 24:
Enter device_Portal in the Device Name field.
Enter the switch's IP address 192.168.75.2 in the IP Address field.
Enter expert in the Key and Confirm Key fields.
Select Directly Connected from the Access Method list.
Use the default values for other parameters.
Figure 24: Configuring a portal device
Click OK.
The new portal device named device_Portal is added to the portal device list, as shown in Figure 25.
Figure 25: Viewing the new portal device
Configuring a port group
In the portal device list, click the Port Group icon
in the Operation column for device_Portal.The Configure Port Group page opens.
On the port group list, click Add.
The Add Port Group page opens.
Configure the port group parameters, as shown in Figure 26:
Enter port_portal in the Port Group Name field.
Select CHAP from the Authentication Type list.
Select portal_test from the IP Group list.
Use the default values for other parameters.
Figure 26: Configuring a port group
Click OK.
The new port group named port_portal is added to the port group list, as shown in Figure 27.
Figure 27: Viewing the new port group
