Viewing PoE when using LLDP information

LLDP port configuration information with PoE

switch(config)# show lldp config 4

 LLCP Port Configuration Detail

  Port : 4
  AdminStatus [Tx_Rx] : Tx_Rx
  NotificationsEnabled [False] : False
  Med Topology Trap Enabled [False] : False


  TLVS Advertised:
   * port_descr
   * system_name
   * system_descr
   * system_cap

   * capabilities
   * network_policy
   * location_id
   * poe

   * macphy_config
   * poeplus_config

  IpAddress Advertised:

Local power information shows an Example: of the local device power information using the show lldp info local-device <port-list> command.

Local power information

switch(config)# show lldp info local-device A1

 LLCP Local Port Information Detail

  Port     : A1
  PortType : local
  PortId   : 1
  PortDesc : A1
  Pvid     : 1

 Poe Plus Information Detail

     Poe Device Type           : Type2 PSE
     Power Source              : Primary
     Power Priority            : low
     PD Requested Power Value  : 20 Watts
     PSE Actual Power Value    : 20 Watts

Remote power information shows the remote device power information using the show lldp info remote-device <port-list> command.

Remote power information

switch(config)# show lldp info remote-device A3

 LLCP Remote Device Information Detail

  Local Port   : A3
  ChassisType  : mac-address
  ChassisId    : 00 16 35 ff 2d 40
  PortType     : local
  PortId       : 23
  SysName      : Switch
  System Descr : Switch, revision YA.14.xx
  PortDescr    : 23
  Pvid         : 55

  System Capabilities Supported  : bridge, router
  System Capabilities Enabled    : bridge

  Remote Management Address
     Type    : ipv4
     Address : 10.0.102.198

  Poe Plus Information Detail

     Poe Device Type           : Type2 PD
     Power Source              : Only PSE
     Power Priority            : low
     PD Requested Power Value  : 20 Watts
     PSE Actual Power Value    : 20 Watts