`rate-limit unknown-unicast in percent`

Syntax

interface port-list rate-limit unknown-unicast in percent 0-100

Description

Sets a rate limit for unicast flood traffic.

Command context

interface

Parameters

in: Sets a rate limit for incoming unicast flood traffic.
percent: Specifies the rate limit as a percentage of the total available bandwidth.
kbps: Specifies the rate limit in Kb/s.

Examples

switch(config)# int 2
switch(eth-2)# rate-limit
all                   Set a rate limit for all traffic.
bcast                 Set a rate limit for broadcast traffic.
icmp                  Set a rate limit for ICMP traffic.
mcast                 Set a rate limit for multicast traffic.
queues                Set a rate limit for each traffic queue.
unknown-unicast       Set a rate limit for unicast flood traffic.
switch(eth-2)# rate-limit unknown-unicast
in                    Set a rate limit for incoming unicast flood traffic.
switch(eth-2)# rate-limit unknown-unicast in
kbps
percent
switch(eth-2)# rate-limit unknown-unicast in percent 10
switch(eth-2)# show rate-limit
 bcast                 Show broadcast traffic rate limits.
 icmp                  Show ICMP traffic rate limits.
 mcast                 Show multicast traffic rate limits.
 queues                Show limits for outgoing queue traffic.
 unknown-unicast       Show unicast flood traffic rate limits.
switch(eth-2)# show rate-limit unknown-unicast
 [ethernet] PORT-LIST  The ports to show information for.

switch(eth-2)# show rate-limit unknown-unicast 2

 Unknown-Unicast Traffic Rate Limit Maximum %

  Port  | Inbound Limit Mode
  ----- + ------------- ---------
  2     | 10            %