Restoring the factory-default configuration

As part of your troubleshooting process, it may become necessary to return the switch configuration to the factory default settings. This process

Momentarily interrupts the switch operation
Clears any passwords
Clears the console Event Log
Resets the network counters to zero
Performs a complete self test
Reboots the switch into its factory default configuration, including deleting an IP address

There are two methods for resetting to the factory-default configuration:

CLI
Clear/Reset button combination


	NOTE: HP recommends that you save your configuration to a TFTP server before resetting the switch to its factory-default configuration. You can also save your configuration via Xmodem to a directly connected PC.

Resetting to the factory-default configuration

Erase start-up config

This command operates at any level except the Operator level.

Syntax:

erase startup-configuration

Deletes the startup-config file in flash so that the switch will reboot with its factory-default configuration.

NOTE: The erase startup-config command does not clear passwords unless include-credentials has been set, at which time this command does erase username/password information and any other credentials stored in the config file.

Using `Clear`/ `Reset`

Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch.
Continue to press the Clear button while releasing the Reset button.
When the Self Test LED begins to flash, release the Clear button.

The switch then completes its self test and begins operating with the configuration restored to the factory default settings.

prev		next
Viewing the information you need to diagnose problems	home	Zeroization


	NOTE: The `erase startup-config` command does not clear passwords unless `include-credentials` has been set, at which time this command does erase username/password information and any other credentials stored in the config file.

Restoring the factory-default configuration

Resetting to the factory-default configuration

Erase start-up config

Syntax:

Using Clear/ Reset

Using `Clear`/ `Reset`