Using the destination Commander CLI to pull a member from another stack
Syntax:
stack member [<switch-number> mac-address password ]<password-str>
In the destination Commander, finds the MAC address of the Member you want to pull into the destination stack.
Stack output with two stacks in the subnet
Suppose that you create a new Commander with
a stack name of Cold_Waters and want to move
a switch named Bering Sea into this new stack:
You would then execute the following command to pull the desired switch into the new stack:
switch(config)#: stack member 1 mac-address 0060b0-df1a00
Where
1is an unused switch number (SN).
Since a password is not set on the Candidate, a password is not needed in this example.
Use show stack all again to
verify that the move took place.