The show
commands for OOBM are similar to the analogous commands for the data plane. Note that you must always include the oobm
parameter to see the information for the OOBM interface, regardless of the context. For instance, even from the OOBM context, the show ip
command displays the IP configuration for the data plane; to see the IP configuration of the OOBM interface, you need to use show oobm ip
.
Showing the global OOBM and OOBM port configuration
Syntax:
Summarizes OOBM configuration information. This command displays the global OOBM configuration (enabled or disabled), the OOBM interface status (up or down), and the port status (enabled/disabled, duplex, and speed).
You can issue this command from any context.
Example:
HP Switch# show oobm
Global Configuration
OOBM Enabled : Yes
OOBM Port Type : 10/100TX
OOBM Interface Status : Up
OOBM Port : Enabled
OOBM Port Speed : Auto
Showing OOBM IP configuration
Syntax:
Summarizes the IP configuration of the OOBM interface. This command displays the status of IPv4 (enabled/disabled), the IPv4 default gateway, and the IPv4 address configured for the interface.
You can issue this command from any context.
Example:
Showing OOBM ARP information
Syntax:
Summarizes the ARP table entries for the OOBM interface.
You can issue this command from any context.
Example: