An Access Control List (ACL) is a list of one or more Access Control Entries (ACEs), where each ACE consists of a matching criteria and an action (permit or deny). The information below describes how to configure, apply, and edit static IPv4 ACLs in a network populated with HP switches, and how to monitor IPv4 ACL actions.
|
|
NOTE: This chapter describes ACLs for IPv4 configuration and operation. In this chapter, unless otherwise noted:
|
|
|
IPv4 filtering with ACLs can help improve network performance and restrict network use by creating policies for:
Switch Management Access: Permits or denies in-band management access. This includes limiting and/or preventing the use of designated protocols that run on top of IPv4, such as TCP, UDP, IGMP, ICMP, and others. Also included are the use of precedence and ToS criteria, and control for application transactions based on source and destination IPv4 addresses and transport layer port numbers.
Application Access Security: Eliminates unwanted traffic in a path by filtering IPv4 packets where they enter or leave the switch on specific VLAN interfaces.
IPv4 ACLs can filter traffic to or from a host, a group of hosts, or entire subnets.
To apply IPv4 ACL filtering, assign a configured IPv4 ACL to the interface on which you want traffic filtering to occur. VLAN and routed IPv4 traffic ACLs can be applied statically using the switch configuration.
Port traffic ACLs can be applied either statically or dynamically (using a RADIUS server).
Static ACLs are configured on the switch. To apply a static ACL, you must assign it to an interface (VLAN or port).
A dynamic port ACL is configured on a RADIUS server for assignment to a given port when the server authenticates a specific client on that port. When the server authenticates a client associated with that ACL, the ACL is assigned to the port the client is using. The ACL then filters the IP traffic received inbound on that port from the authenticated client. When the client session ends, the ACL is removed from the port. The switch allows as many dynamic port ACLs on a port as it allows authenticated clients.