lldp compliance admin-status cdp
Use lldp compliance admin-status cdp to set the operating mode of CDP-compatible LLDP.
Use undo lldp compliance admin-status cdp to restore the default.
Syntax
lldp compliance admin-status cdp { disable | rx | txrx }
undo lldp compliance admin-status cdp
Default
CDP-compatible LLDP operates in Disable mode.
Views
Layer 2 Ethernet interface view
Layer 3 Ethernet interface view
Management Ethernet interface view
Predefined user roles
network-admin
mdc-admin
Parameters
disable: Specifies the Disable mode. CDP-compatible LLDP in this mode cannot receive or transmit CDP packets.
txrx: Specifies the TxRx mode. CDP-compatible LLDP in this mode can send and receive CDP packets.
rx: Specifies the Rx mode. CDP-compatible LLDP in this mode can receive but cannot send CDP packets.
Usage guidelines
For your device to work with Cisco IP phones, you must perform the following tasks:
Enable CDP-compatible LLDP globally.
Configure CDP-compatible LLDP to operate in TxRx mode on the specified ports.
Examples
# Enable CDP-compatible LLDP globally and configure CDP-compatible LLDP to operate in TxRx mode on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view [Sysname] lldp compliance cdp [Sysname] interface ten-gigabitethernet 1/0/1 [Sysname-Ten-GigabitEthernet1/0/1] lldp compliance admin-status cdp txrx
Related commands
lldp compliance cdp