An RP cannot join an SPT in PIM-SM

Symptom

An RPT cannot be correctly built, or an RP cannot join the SPT toward the multicast source.

To resolve the problem:

Use display ip routing-table to verify that a unicast route to the RP is available on each device.
Use display pim rp-info to verify that the dynamic RP information is consistent on all devices.
Use display pim rp-info to verify that the same static RPs are configured on all devices on the network.
If the problem persists, contact Hewlett Packard Enterprise Support.

prev	up	next
Multicast data is abnormally terminated on an intermediate device	home	An RPT cannot be built or multicast source registration fails in PIM-SM