Configuring a static member port

You can configure a port as a static member port for a multicast group so that hosts attached to the port can always receive multicast for the group. The static member port does not respond to IGMP queries. When you complete or cancel this configuration on a port, the port does not send an unsolicited IGMP report or leave message.

1. Enter system view.

   system-view

2. Enter Layer 2 interface view.

   • Enter Layer 2 Ethernet interface view.

     interface interface-type interface-number

   • Enter Layer 2 aggregate interface view.

     interface bridge-aggregation interface-number

3. Configure the port as a static member port.

   igmp-snooping static-group group-address [ source-ip source-address ] vlan vlan-id

   By default, a port is not a static member port.