IP multicast addresses
IPv4 multicast addresses
IANA assigned the Class D address block (224.0.0.0 to 239.255.255.255) to IPv4 multicast.
Table 2: Class D IP address blocks and description
Address block | Description |
|---|---|
224.0.0.0 to 224.0.0.255 | Reserved permanent group addresses. The IP address 224.0.0.0 is reserved. Other IP addresses can be used by routing protocols and for topology searching, protocol maintenance, and so on. Table 3 lists common permanent group addresses. A packet destined for an address in this block will not be forwarded beyond the local subnet regardless of the TTL value in the IP header. |
224.0.1.0 to 238.255.255.255 | Globally scoped group addresses. This block includes the following types of designated group addresses:
|
239.0.0.0 to 239.255.255.255 | Administratively scoped multicast addresses. These addresses are considered locally unique rather than globally unique. You can reuse them in domains administered by different organizations without causing conflicts. For more information, see RFC 2365. |
![[NOTE: ]](images/note.png) | NOTE: Glop is a mechanism for assigning multicast addresses between different ASs. By filling an AS number into the middle two bytes of 233.0.0.0, you get 255 multicast addresses for that AS. For more information, see RFC 2770. | |
Table 3: Common permanent multicast group addresses
Address | Description |
|---|---|
224.0.0.1 | All systems on this subnet, including hosts and routers. |
224.0.0.2 | All multicast routers on this subnet. |
224.0.0.3 | Unassigned. |
224.0.0.4 | DVMRP routers. |
224.0.0.5 | OSPF routers. |
224.0.0.6 | OSPF designated routers and backup designated routers. |
224.0.0.7 | Shared Tree (ST) routers. |
224.0.0.8 | ST hosts. |
224.0.0.9 | RIPv2 routers. |
224.0.0.11 | Mobile agents. |
224.0.0.12 | DHCP server/relay agent. |
224.0.0.13 | All Protocol Independent Multicast (PIM) routers. |
224.0.0.14 | RSVP encapsulation. |
224.0.0.15 | All Core-Based Tree (CBT) routers. |
224.0.0.16 | Designated SBM. |
224.0.0.17 | All SBMs. |
224.0.0.18 | VRRP. |
IPv6 multicast addresses
Figure 4: IPv6 multicast format
The following describes the fields of an IPv6 multicast address:
0xFF—The most significant eight bits are 11111111.
Flags—The Flags field contains four bits.
Figure 5: Flags field format
Table 4: Flags field description
Bit
Description
0
Reserved, set to 0.
R
When set to 0, this address is an IPv6 multicast address without an embedded RP address.
When set to 1, this address is an IPv6 multicast address with an embedded RP address. (The P and T bits must also be set to 1.)
P
When set to 0, this address is an IPv6 multicast address not based on a unicast prefix.
When set to 1, this address is an IPv6 multicast address based on a unicast prefix. (The T bit must also be set to 1.)
T
When set to 0, this address is an IPv6 multicast address permanently-assigned by IANA.
When set to 1, this address is a transient or dynamically assigned IPv6 multicast address.
Scope—The Scope field contains four bits, which represent the scope of the IPv6 internetwork for which the multicast traffic is intended.
Table 5: Values of the Scope field
Value
Meaning
0, F
Reserved.
1
Interface-local scope.
2
Link-local scope.
3
Subnet-local scope.
4
Admin-local scope.
5
Site-local scope.
6, 7, 9 through D
Unassigned.
8
Organization-local scope.
E
Global scope.
Group ID—The Group ID field contains 112 bits. It uniquely identifies an IPv6 multicast group in the scope that the Scope field defines.
