san-aggregation group

Use san-aggregation group to assign an FC interface to an FC aggregation group.

Use undo san-aggregation group to remove an FC interface from an FC aggregation group.

Syntax

san-aggregation group group-id

undo san-aggregation group

Default

An FC interface is not assigned to any FC aggregation group.

Views

FC interface view

Predefined user roles

network-admin

Parameters

group-id: Specifies an FC aggregation group by its group number. An FC aggregation group uniquely corresponds to an FC aggregate interface, and they are numbered the same. The value range for this argument is 1 to 1024.

Usage guidelines

An FC interface can be assigned to only one FC aggregation group.

After an FC interface is assigned to an FC aggregation group, its operating mode, trunk mode, trunk VSAN, and access VSAN settings are cleared. Also, you cannot configure these settings for a member port. After the FC interface is removed from the FC aggregation group, these settings are not restored, and the default settings are used.

The number of member interfaces that an FC aggregation group supports is 8.

Examples

# Assign FC 1/0/1 to FC aggregation group 1.

<Sysname> system-view
[Sysname] interface 
[Sysname-Fc1/0/1] san-aggregation group 1

Related commands

display san-aggregation