Configuring an aggregate interface > Configuring an edge aggregate interface

Configuring an edge aggregate interface

When you configure an edge aggregate interface, follow these restrictions and guidelines:

This configuration takes effect only on the aggregate interface corresponding to a dynamic aggregation group.
Link-aggregation traffic redirection does not operate correctly on an edge aggregate interface. For more information about link-aggregation traffic redirection, see "Enabling link-aggregation traffic redirection."

To configure an edge aggregate interface:

Step	Command	Remarks
1. Enter system view.	system-view	N/A
2. Enter aggregate interface view.	Enter Layer 2 aggregate interface view:interface bridge-aggregation interface-number Enter Layer 3 aggregate interface view:interface route-aggregation interface-number	N/A
3. Configure the aggregate interface as an edge aggregate interface.	lacp edge-port	By default, an aggregate interface does not operate as an edge aggregate interface.

prev	up	next
Setting the expected bandwidth for an aggregate interface	home	Enabling BFD for an aggregation group

© Copyright 2017 Hewlett Packard Enterprise Development LP