Configuring a static aggregation group
To guarantee a successful static aggregation, make sure that the ports at both ends of each link are in the same aggregation state.
Avoid assigning ports to a static aggregation group that has reached the limit on Selected ports. These ports will be placed in the Unselected state to avoid traffic interruption on the current Selected ports. However, a device reboot can cause the aggregation state of member ports to change.
Configuring a Layer 2 static aggregation group
Step | Command | Remarks |
|---|---|---|
1. Enter system view. | system-view | N/A |
2. Create a Layer 2 aggregate interface and enter Layer 2 aggregate interface view. | interface bridge-aggregation interface-number | When you create a Layer 2 aggregate interface, the system automatically creates a Layer 2 static aggregation group numbered the same. |
3. Exit to system view. | quit | N/A |
4. Assign an interface to the specified Layer 2 aggregation group. | Enter Layer 2 Ethernet interface view:interface interface-type interface-number Assign the interface to the specified Layer 2 aggregation group:port link-aggregation group number | Repeat these two sub-steps to assign more Layer 2 Ethernet interfaces to the aggregation group. |
Configuring a Layer 3 static aggregation group
Step | Command | Remarks |
|---|---|---|
1. Enter system view. | system-view | N/A |
2. Create a Layer 3 aggregate interface and enter Layer 3 aggregate interface view. | interface route-aggregation interface-number | When you create a Layer 3 aggregate interface, the system automatically creates a Layer 3 static aggregation group numbered the same. |
3. Exit to system view. | quit | N/A |
4. Assign an interface to the specified Layer 3 aggregation group. | Enter Layer 3 Ethernet interface view:interface interface-type interface-number Assign the interface to the specified Layer 3 aggregation group:port link-aggregation group number | Repeat these two sub-steps to assign more Layer 3 Ethernet interfaces to the aggregation group. |