smart-link flush enable

Use smart-link flush enable to enable the flush message receiving function.

Use undo smart-link flush enable to remove the configuration.

Syntax

smart-link flush enable [ control-vlan vlan-id-list ]

undo smart-link flush enable [ control-vlan vlan-id-list ]

Default

Flush messages are not processed.

Views

Layer 2 Ethernet interface view, Layer 2 aggregate interface view

Predefined user roles

network-admin

Parameters

control-vlan vlan-id-list: Specifies the control VLANs used for receiving flush messages. The default is 1. The vlan-id-list is expressed in the form of vlan-id-list = { vlan-id [ to vlan-id ] }&<1-10>, where the vlan-id argument represents the ID of a control VLAN in the range of 1 to 4094. &<1-10> indicates that you can provide up to 10 VLAN IDs or VLAN ID lists.

Examples

# Enable Ten-GigabitEthernet 1/0/1 to process the flush messages received in VLAN 1.

<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] smart-link flush enable

# Enable Layer 2 aggregate interface 1 to process the flush messages received in VLAN 1.

<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] smart-link flush enable

Related commands

flush enable