cfd ais-track link-status period

Use cfd ais-track link-status period to configure the EAIS frame transmission period.

Use undo cfd ais-track link-status period to restore the default.

Syntax

cfd ais-track link-status period period-value

undo cfd ais-track link-status period

Default

The EAIS frame transmission period is not configured.

Views

Layer 2 Ethernet interface view, Layer 2 aggregate interface view

Predefined user roles

network-admin

Parameters

period period-value: Specifies the EAIS frame transmission period in the range of 1 to 60 seconds.

Usage guidelines

If no EAIS frame transmission period is configured on a port, the port cannot send EAIS frames.

Follow these guidelines when you use this command:

• Configurations in Ethernet interface view take effect only on the current interface.

• Configurations in aggregate interface view take effect on the aggregate interface and all its member ports.

• Configurations on a member port take effect only when the member port leaves the aggregation group.

Examples

# Configure the EAIS frame transmission period as 60 seconds on Ten-GigabitEthernet 1/0/1.

<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] cfd ais-track link-status period 60

Related commands

• cfd ais-track link-status global

• cfd ais-track link-status level

• cfd ais-track link-status vlan