Automatic configuration using HTTP server and Tcl script

Network requirements

As shown in Figure 8, Switch A does not have a configuration file.

Configure the servers so Switch A can obtain a Tcl script to complete the following configuration tasks:

Figure 42: Network diagram

Configuration procedure

  1. Configure the DHCP server:

    # Enable DHCP.

    <DeviceA> system-view
    [DeviceA] dhcp enable
    

    # Configure address pool 1 to assign IP addresses on subnet 192.168.1.0/24 to clients.

    [DeviceA] dhcp server ip-pool 1
    [DeviceA-dhcp-pool-1] network 192.168.1.0 24
    

    # Specify the URL of the script file for the clients.

    [DeviceA-dhcp-pool-1] bootfile-name http://192.168.1.40/device.tcl
    
  2. Configure the HTTP server:

    # Edit the configuration file device.tcl on the HTTP server.

    return
    system-view
    telnet server enable
    local-user user
    password simple abcabc
    service-type telnet
    quit
    user-interface vty 0 4
    authentication-mode scheme
    user-role network-admin 
    quit
    
    interface Ten-GigabitEthernet 1/0/1
    port link-mode route
    ip address dhcp-alloc
    return
    

    # Start HTTP service software and enable HTTP service. (Details not shown.)

Verifying the configuration

  1. Power on Switch A.

  2. After Switch A starts up, display assigned IP addresses on Device A.

    <DeviceA> display dhcp server ip-in-use
    IP address       Client identifier/    Lease expiration      Type
                     Hardware address
    192.168.1.2      0030-3030-632e-3239-  Dec 12 17:41:15 2013  Auto(C)
                     3035-2e36-3736-622d-
                     4574-6830-2f30-2f32
    
  3. Telnet to 192.168.1.2 from Device A.

    <DeviceA> telnet 192.168.1.2
    
  4. Enter the username user and password abcabc as prompted. (Details not shown.)

    You are logged in to Switch A.