display ospfv3 vlink
Use display ospfv3 vlink to display OSPFv3 virtual link information.
Syntax
display ospfv3 [ process-id ] vlink
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
process-id: Specifies an OSPFv3 process by its ID in the range of 1 to 65535. If you do not specify this argument, the command displays the OSPFv3 virtual link information for all OSPFv3 processes.
Examples
# Display OSPFv3 virtual link information.
<Sysname> display ospfv3 vlink
OSPFv3 Process 1 with Router ID 1.1.1.1
Virtual-link Neighbor-id: 12.2.2.2, Neighbor-state: Full
Interface: 2348 (Vlan-interface12), Instance-ID: 0
Local IPv6 address: 3:3333::12
Remote IPv6 address: 2:2222::12
Cost: 1 State: P-2-P Type: Virtual
Transit area: 0.0.0.1
Timers: Hello 10, Dead 40, Retransmit 5, Transmit Delay 1
IPsec profile name: profile001
Keychain authentication: Enabled (test), inherited
Table 165: Command output
Field | Description |
|---|---|
Virtual-link Neighbor-ID | ID of the neighbor on the virtual link. |
Neighbor-State | Neighbor state: Down, Init, 2-Way, ExStart, Exchange, Loading, or Full. |
Interface | Number and name of the local interface on the virtual link. |
Cost | Interface route cost. |
State | Interface state. |
Type | Virtual link. |
Transit Area | Transit area ID. This field is displayed when a virtual link is present on the interface. |
Timers | Values of OSPFv3 timers (in seconds): Hello, Dead, and Retransmit. |
Transmit Delay | LSA transmission delay on the interface, in seconds. |
IPsec profile name | IPsec profile applied to the virtual link. |
Keychain authentication: Enabled (test), inherited | Keychain authentication is enabled for the virtual link, and the keychain test is used. The inherited attribute indicates that the virtual link is using the authentication mode specified for the backbone area. |