rip bfd enable destination

Use rip bfd enable destination to enable BFD single-hop echo detection for a specific destination.

Use undo rip bfd enable to disable BFD single-hop echo detection for RIP.

Syntax

rip bfd enable destination ip-address

undo rip bfd enable

Default

BFD single-hop echo detection for a specific destination is disabled on an interface.

Views

Interface view

Predefined user roles

network-admin

Usage guidelines

When a link failure occurs between the local device and the specified neighbor, BFD can detect the failure. The local device will not receive or send any RIP packets through the interface connected to the neighbor.

The rip bfd enable destination command applies only to BFD echo-mode detection.

The rip bfd enable destination command and the rip bfd enable command are mutually exclusive and cannot be configured on a device at the same time.

Examples

# Enable BFD on VLAN-interface 10 for a specific destination 202.38.165.1.

<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip bfd enable destination 202.38.165.1