Contents
-
Configuring basic IP routing -
-
Routing table -
Dynamic routing protocols -
Route preference -
Route backup -
Route recursion -
Route redistribution -
Extension attribute redistribution -
Setting the maximum lifetime for routes and labels in the RIB -
Setting the maximum lifetime for routes in the FIB -
Configuring RIB NSR -
Configuring inter-protocol FRR -
Enabling support for IPv6 routes with prefixes longer than 64 bits -
Configuring routing policy-based recursive lookup -
Displaying and maintaining a routing table
-
-
Configuring static routing -
Configuring a default route -
Configuring RIP -
-
Overview -
RIP configuration task list -
Configuring basic RIP -
Configuring RIP route control -
Tuning and optimizing RIP networks -
-
Configuration prerequisites -
Setting RIP timers -
Enabling split horizon and poison reverse -
Enabling zero field check on incoming RIPv1 messages -
Enabling source IP address check on incoming RIP updates -
Configuring RIPv2 message authentication -
Setting the RIP triggered update interval -
Specifying a RIP neighbor -
Configuring RIP network management -
Configuring the RIP packet sending rate -
Setting the maximum length of RIP packets -
Setting the DSCP value for outgoing RIP packets
-
-
Configuring RIP GR -
Enabling RIP NSR -
Configuring BFD for RIP -
Configuring RIP FRR -
Displaying and maintaining RIP -
RIP configuration examples -
-
Configuring basic RIP -
Configuring RIP route redistribution -
Configuring an additional metric for a RIP interface -
Configuring RIP GR -
Configuring RIP NSR -
Configuring BFD for RIP (single-hop echo detection for a directly connected neighbor) -
Configuring BFD for RIP (single hop echo detection for a specific destination) -
Configuring BFD for RIP (bidirectional detection in BFD control packet mode) -
Configuring RIP FRR
-
-
-
Configuring PBR -
Configuring IPv6 static routing -
Configuring an IPv6 default route -
Configuring RIPng -
Configuring routing policies -
Document conventions and icons -
Support and other resources