Enabling BFD for RIP FRR
By default, RIP FRR does not use BFD to detect primary link failures. To speed up RIP convergence, enable BFD single-hop echo detection for RIP FRR to detect primary link failures.
To configure BFD for RIP FRR:
Step | Command | Remarks |
|---|---|---|
1. Enter system view. | system-view | N/A |
2. Configure the source IP address of BFD echo packets. | bfd echo-source-ip ip-address | By default, the source IP address of BFD echo packets is not configured. The source IP address cannot be on the same network segment as any local interface's IP address. For more information about this command, see High Availability Command Reference. |
3. Enter interface view. | interface interface-type interface-number | N/A |
4. Enable BFD for RIP FRR. | rip primary-path-detect bfd echo | By default, BFD for RIP FRR is disabled. |