Configuration procedure
Configuring RIP FRR
Step | Command | Remarks |
|---|---|---|
1. Enter system view. | system-view | N/A |
2. Configure the source address of echo packets. | bfd echo-source-ip ip-address | By default, the source address of echo packets is not configured. |
3. Enter RIP view. | rip [ process-id ] | N/A |
4. Configure RIP FRR. | fast-reroute route-policy route-policy-name | By default, RIP FRR is disabled. |
Enabling BFD for RIP FRR
By default, RIP FRR does not use BFD to detect primary link failures. To speed up RIP convergence, enable BFD single-hop echo detection for RIP FRR to detect primary link failures.
To configure BFD for RIP FRR:
Step | Command | Remarks |
|---|---|---|
1. Enter system view. | system-view | N/A |
2. Configure the source IP address of BFD echo packets. | bfd echo-source-ip ip-address | By default, the source IP address of BFD echo packets is not configured. |
3. Enter interface view. | interface interface-type interface-number | N/A |
4. Enable BFD for RIP FRR. | rip primary-path-detect bfd echo | By default, BFD for RIP FRR is disabled. |