vrrp vrid track

Syntax

vrrp vrid virtual-router-id track track-entry-number [ forwarder-switchover member-ip ip-address | reduced priority-reduced | switchover ]

undo vrrp vrid virtual-router-id track [ track-entry-number ]

View

Interface view

Default level

2: System level

Parameters

virtual-router-id: Specifies a VRRP group number, which ranges from 1 to 255.

track track-entry-number: Specifies a track entry. The track-entry-number argument ranges from 1 to 1024.

forwarder-switchover member-ip ip-address: Enables the LVF on the router to take over the role of the AVF at the specified IP address immediately after the specified track entry changes to the negative state. You can use the display vrrp verbose command to view the IP addresses of VFs.

reduced priority-reduced: Reduces the priority of the router in the VRRP group by a specific value when the state of the specified track entry changes to the negative state. The priority-reduced argument ranges from 1 to 255.

switchover: Enables the router in backup state to take over as the master immediately after the specified track entry changes to the negative state.

Description

Use vrrp vrid track to associate a VRRP group with a track entry and control master switchover or AVF switchover in the VRRP group in response to changes (such as uplink state changes) detected by the track entry.

Use undo vrrp vrid track to remove the association between a VRRP group and a track entry. If no track entry is specified, the association between the VRRP group and any track entry is removed.

By default, a VRRP group is not associated with any track entry.

When the associated track entry changes to the negative state, the priority of the router in the VRRP group decreases by a specified value, or the router immediately takes over as the master if it is a backup router, or the LVF on the router immediately takes over the role of the AVF at the specified IP address, depending on your configuration.

If forwarder-switchover member-ip ip-address, reduced priority-reduced, and switchover are not specified, the priority of the router in the VRRP group decreases by 10 when the track entry changes to negative.

When the track entry changes from negative to positive or invalid, the router automatically restores its priority.

You must create the VRRP group and assign a virtual IP address to it before you can associate it with any track entry.

The vrrp vrid track command cannot take effect on an IP address owner. If you have configured the command on an IP address owner, the configuration takes effect after the router changes to be a non IP address owner.

You can create a track entry with the track command before or after you associate it with a VRRP group. For more information about configuring track entries, see High Availability Configuration Guide.

Related commands: vrrp vrid track interface and display vrrp.

Examples

# Associate VRRP group 1 on VLAN-interface 2 with track entry 1 and decrease the priority of the router in the VRRP group by 50 when the state of track entry 1 changes to negative.

<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1
[Sysname-Vlan-interface2] vrrp vrid 1 track 1 reduced 50

# Associate VRRP group 1 on VLAN-interface 2 with track entry 2 and enable the VF in listening state whose AVF is on the member device with the IP address of 10.1.1.3 to take over as the AVF immediately after the specified track entry changes to the negative state.

[Sysname-Vlan-interface2] vrrp vrid 1 track 2 forwarder-switchover member-ip 10.1.1.3