mld-snooping host-aging-time

Use mld-snooping host-aging-time to set the aging timer for dynamic member ports in a VLAN.

Use undo mld-snooping host-aging-time to restore the default.

Syntax

mld-snooping host-aging-time seconds

undo mld-snooping host-aging-time

Default

The aging timer for dynamic member ports is 260 seconds.

Views

VLAN view

Predefined user roles

network-admin

mdc-admin

Parameters

seconds: Specifies an aging timer for dynamic member ports, in the range of 1 to 8097894 seconds.

Usage guidelines

You must enable MLD snooping for a VLAN before you execute this command.

You can set the timer for a VLAN in VLAN view or globally for all VLANs in MLD-snooping view. For a VLAN, the VLAN-specific configuration takes priority over the global configuration.

To avoid mistakenly deleting IPv6 multicast group members, set the aging timer for dynamic member ports to be greater than the value calculated by using the following formula:

[ MLD general query interval ] + [ maximum response time for MLD general queries ]

As a best practice, set the aging timer of dynamic member ports to the value calculated by using the following formula:

[ MLD general query interval ] × 2 + [ maximum response time for MLD general queries ]

Examples

# In VLAN 2, enable MLD snooping, and set the aging timer for dynamic member ports in the VLAN to 300 seconds.

<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping host-aging-time 300

Related commands

enable (MLD-snooping view)

host-aging-time (MLD-snooping view)

mld-snooping enable