No membership information on the receiver-side router
Symptom
When a host sends a report for joining the multicast group G, no membership information of the multicast group G exists on the router closest to that host.
Solution
To resolve the problem:
Use the display igmp interface command to verify that the networking, interface connection, and IP address configuration are correct.
Use the display current-configuration command to verify that multicast routing is enabled. If it is not enabled, use the multicast routing command in system view to enable IP multicast routing. In addition, verify that IGMP is enabled on the associated interfaces.
Use the display igmp interface command to verify that the IGMP version on the interface is lower than that on the host.
Use the display current-configuration interface command to verify that no ACL rule has been configured to filter out the reports for the multicast group G.
If the problem persists, contact Hewlett Packard Enterprise Support.