default local-preference

Use default local-preference to configure a default local preference.

Use undo default local-preference to restore the default.

Syntax

default local-preference value

undo default local-preference

Default

The default local preference is 100.

Views

BGP IPv4 unicast address family view, BGP-VPN IPv4 unicast address family view, BGP IPv6 unicast address family view, BGP-VPN IPv6 unicast address family view

Predefined user roles

network-admin

mdc-admin

Parameters

value: Specifies a default local preference in the range of 0 to 4294967295. The larger the value, the higher the preference.

Usage guidelines

You can also use the apply local-preference command in a routing policy to configure the local preference for BGP routes. If no routing policy is configured, all BGP routes use the local preference set by the default local-preference command. If a routing policy is configured, BGP routes matching the routing policy use the local preference set by the apply local-preference command, and other BGP routes use the local preference set by the default local-preference command.

Examples

# In BGP IPv4 unicast address family view, set the default local preference to 180.

<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] address-family ipv4 unicast
[Sysname-bgp-ipv4] default local-preference 180

# In BGP-VPN IPv6 unicast address family view, set the default local preference to 180.

<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ip vpn-instance vpn1
[Sysname-bgp-vpn1] address-family ipv6 unicast
[Sysname-bgp-ipv6-vpn1] default local-preference 180

Related commands

apply local-preference

route-policy