vrrp vrid

Use vrrp vrid to create an IPv4 VRRP group and assign a virtual IP address to the IPv4 VRRP group or assign a virtual IP address to an existing IPv4 VRRP group.

Use undo vrrp vrid to remove all configurations of an existing IPv4 VRRP group or to remove a virtual IP address from an existing IPv4 VRRP group.

Syntax

vrrp vrid virtual-router-id virtual-ip virtual-address

undo vrrp vrid virtual-router-id [ virtual-ip [ virtual-address ] ]

Default

No IPv4 VRRP group is created.

Views

Interface view

Predefined user roles

network-admin

mdc-admin

Parameters

virtual-router-id: Specifies an IPv4 VRRP group by its virtual router ID in the range of 1 to 255.

virtual-ip virtual-address: Specifies a virtual IP address, which cannot be an all-zero address (0.0.0.0); a broadcast address (255.255.255.255); a loopback address; an IP address of other than Class A, Class B, and Class C; or an invalid IP address (for example, 0.0.0.1). If this argument is not specified, the undo vrrp vrid command removes all virtual IP addresses from the existing IPv4 VRRP group.

Usage guidelines

You can assign up to 16 virtual IP addresses to an IPv4 VRRP group.

If you create an IPv4 VRRP group but do not assign any virtual IP address to it, the VRRP group stays in inactive state and does not function.

The virtual IP addresses of an IPv4 VRRP group must be in the same subnet as one of the IP addresses of the interface where the VRRP group is configured. Otherwise, the hosts in the subnet cannot access external networks.

Examples

# Create IPv4 VRRP group 1 and assign virtual IP address 10.10.10.10 to the VRRP group. Then assign virtual IP address 10.10.10.11 to the VRRP group.

<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.10.10.10
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.10.10.11

Related commands

display vrrp