Installation procedure
IMPORTANT:
| ||
To install a card:
Remove the protection cover before installing an MPU or an LPU. Skip this step if the card does not have a protection cover:
Wear an ESD wrist strap and then loosen the captive screws that attach the MPU or the LPU to the protection cover with a Philips screwdriver.
Pull the MPU or the LPU out of the protection cover gently.
Figure 28: Removing the protection cover
Move the ejector levers on the front panel of the MPU outwards, hold up the MPU by one hand without touching any electronic components on the MPU, and hold the front panel by the other hand to push the MPU into the slot along the slide rails slowly.
Push the ejector levers inward to ensure close contact between the MPU and the backplane.
Position the screws into the holes and fasten them with a screwdriver to attach the MPU.
Figure 29: Installing an MPU